shock absorber Lancing

DISTRESS Do not hold piston rods by any tools (pliers, etc.). Do not pour mineral water, oil or any various other liquid column housing as this will damage the cartridge. Do not use strength tools for tightening and loosening nuts around the piston rod. Impact wrench can tighten the higher torque than recommended. During installation KYB jolt absorbers use all mounting hardware (nuts, spacers, washers or other elements) within the package. Some KYB shock absorbers will vary slightly in decoration from the original jolt absorber. If the vehicle had been recently replaced original shock absorbers another brand during the assembly could be applied some parts (Airborne dirt and dust cover, stop, sleeves etc.) that cannot provide for KYB shock absorber construction. Shock absorbers should always be replaced in pairs around the axis. It is recommended that at least three "pumping" damper previous to installation. Before tightening the jolt absorbers mounted, ensure the correct position in the other elements of this suspension. SPRING When replacing the utilization of appropriate tools - a new clamp to springs and also the appropriate overlay. The springs should always be replaced in pairs when using axle to ensure equal ground clearance and steer clear of tipping the vehicle to a single side when braking. During the assembly and disassembly have to be careful to avoid harm while uncontrolled expansion. After installation, check suspension geometry. When replacing the spg, it is recommended in which simultaneous replacement shock absorbers. Worn or broken springs can can damage shock absorbers.