shock absorber Clogher

SHOCK Do not hold piston rods by any tools (pliers, etc.). Do not pour h2o, oil or any different liquid column housing as this will damage the cartridge. Do not use energy tools for tightening and loosening nuts for the piston rod. Impact wrench can tighten the bigger torque than recommended. During installation KYB surprise absorbers use all increasing hardware (nuts, spacers, washers or other elements) from the package. Some KYB shock absorbers can vary slightly in theme from the original surprise absorber. If the vehicle had recently been replaced original shock absorbers another brand during the assembly could be utilized some parts (Dirt cover, stop, sleeves etc.) that cannot supply for KYB shock absorber construction. Shock absorbers should always be replaced in pairs for the axis. It is recommended that at the least three "pumping" damper ahead of installation. Before tightening the surprise absorbers mounted, ensure the correct position of the other elements of the suspension. SPRING When replacing the usage of appropriate tools - any clamp to springs plus the appropriate overlay. The springs should always be replaced in pairs while on an axle to ensure equal ground clearance and steer clear of tipping the vehicle one side when braking. During the assembly and disassembly should be careful to avoid personal injury while uncontrolled expansion. After installation, check suspension geometry. When replacing the spring, it is recommended in which simultaneous replacement shock absorbers. Worn or broken springs can affect shock absorbers.