shock absorber Andover

GREAT SHOCK Do not hold piston fishing rod by any tools (pliers, etc.). Do not pour water, oil or any additional liquid column housing as this would damage the cartridge. Do not use power tools for tightening and loosening nuts within the piston rod. Impact wrench can tighten the bigger torque than recommended. During installation KYB shock absorbers use all rising hardware (nuts, spacers, washers or other elements) inside package. Some KYB shock absorbers can vary slightly in theme from the original shock absorber. If the vehicle had been replaced original shock absorbers another brand over the assembly could be utilized some parts (Airborne debris cover, stop, sleeves etc.) that cannot double for KYB shock absorber construction. Shock absorbers should continually be replaced in pairs within the axis. It is recommended that a minimum of three "pumping" damper just before installation. Before tightening the shock absorbers mounted, ensure the correct position on the other elements of the suspension. SPRING When replacing the usage of appropriate tools - some sort of clamp to springs as well as the appropriate overlay. The springs should continually be replaced in pairs while on an axle to ensure equal ground clearance and steer clear of tipping the vehicle to 1 side when braking. During the assembly and disassembly should be careful to avoid personal injury while uncontrolled expansion. After installation, check suspension geometry. When replacing the spg, it is recommended that will simultaneous replacement shock absorbers. Worn or broken springs can affect shock absorbers.